Dual TBI EFI System w/Pertronix/Points Distributor Ignition


2-TBI EFI System w/Pertronix/Points Distributor Ignition:  This kit is the simplest to install and run of all the EFI systems and is classified as a “fuel only” install.  The ECM calculates fuel delivery based on the engine sensors and RPM information from the trigger wheel.  This module  controls the timing and firing events.  TIMING IS NOT CONTROLLED BY THE ECM on this kit, but is very simple, starts quick and runs well.   The Pertronix has been around for many years and has a reputation of being dependable and simple to repair.  This fuel injection system connects to your coil and gets its RPM information from there.  Yes… its could be used with points, but ask yourself why.  Pertronix 1162A can be purchased from many vendors and Pertronix on Amazon.  If you plan to install Air Conditioning, the AC pulley will interfere with the Trigger wheel and will require you send your Harmonic Balancer to us for modification and a special type of trigger wheel. 

Kit Contents

1 ea    Throttle body assembly w/Injector, Idle Advance, Integral MAT and TPS

1 ea    Throttle body assembly w/Injector

1 ea    Fuel Line Right Side

1 ea    Fuel Line Left Side

1 ea    Fuel Line “T” to Tunnel Line

1 ea    “S” Fuel Line from Tank To FPR

1 ea    Fuel Pressure Regulator/Filter

1 ea    Map Sensor, GM Type

1 ea    Narrow Band O2 Sensor

1 ea    Head/Engine Temp Sensor

1 ea    Fuel pump block-off with O-Ring

1 ea    Wiring Harness with Relays w/Opto-Isolator

1 ea    30 amp fuse assembly

1 ea    ECM Computer (programmed and user adjustable)

1 ea    Idle Air Control System

1 ea    USB to 2.5mm ECM to Laptop Cable

1 ea    36-1 Trigger Wheel w/bolts and spacers

1 ea    Trigger Sensor Bracket

1 ea    Trigger Pickup Sensor

2 ea    *Carburetor cores required   
Cores:   Send your cores when you order to allow time for the modifications to these items and avoid delays.  Your cores are must have a fairly straight Bell Crank, a throttle plate and throttle shaft that is free.  We only need the carb base, so remove the top before sending.  Unusable bases have to be thrown away, wastes your shipping and another set of cores will be needed.  A core charge will be charged for each unusable core.
Did you know that Brown EFI is intended for off-road use only?