Dual TBI EFI System with your TSP Distributor


BYOD:  (Bring your own distributor)

2-TBI EFI System with YOUR TSP distributor:  You must have a TSP (Ready to Run) type of distributor for this install or plan to purchase one from a TSP Re-seller.   This kit is the simplest to install and run of all the EFI systems and is classified as a “fuel only” install.  The ECM calculates fuel delivery based on the engine sensors and RPM information from the electronic distributor.  The distributor has its own electronic module which controls the timing and firing information. TIMING IS NOT CONTROLLED BY THE ECM on this kit, but is very simple, starts quick and runs well.  The distributor on these kits are the GM DIS/Pin type (Black).  We do NOT provide spark plug wires or coil for this kit, but can be purchased from us for $35.00/set with the kit (while supplies last).  Plug wires are also available from other vendors in many colors if desired.  You will need a laptop and cable to program the ECM if you want different running parameters (tuning) than stock and is very useful for diagnostics and its just plan cool.

NOTE:  The TSP Distributor is not included in this kit.  Part number JM7732BK for black or JM7732R for red from TSP re-sellers.


Kit Contents

1 ea    Throttle body assembly w/Injector, Idle Advance, Integral MAT and TPS

1 ea    Throttle body assembly w/Injector

1 ea    Fuel Line Right Side

1 ea    Fuel Line Left Side

1 ea    Fuel Line “T” to Tunnel Line

1 ea    “S” Fuel Line from Tank To FPR

1 ea    Fuel Pressure Regulator/Filter

1 ea    Map Sensor, GM Type

1 ea    Narrow Band O2 Sensor

1 ea    Head/Engine Temp Sensor

1 ea    Fuel pump block-off with O-Ring

1 ea    Wiring Harness with Relays for TSP Distributor Kit

1 ea    30 amp fuse assembly

1 ea    ECM Computer (programmed and user adjustable)

1 ea    Idle Air Control System

1 ea    USB to 2.5mm ECM to Laptop Cable

2 ea    *Carburetor cores required  

Cores:   Send your cores when you order to allow time for the modifications to these items and avoid delays.  Your cores are must have a fairly straight Bell Crank, a throttle plate and throttle shaft that is free.  We only need the carb base, so remove the top before sending.  Unusable bases have to be thrown away, wastes your shipping and another set of cores will be needed.  A core charge will be charged for kits with unusable cores.
Did you know that Brown EFI is intended for off-road use only?