Four TBI EFI System with your Pertronix distributor

B4202: 

4-TBI EFI System with your Pertronix distributor included :  You must have a Pertronix type of distributor (preferably running) for this install or plan to purchase one.  This kit is the simplest to install and run of all the EFI systems and is classified as a “fuel only” install.  The ECM calculates fuel delivery based on the engine sensors and RPM information from crank mounted trigger wheel.  The distributor has its own electronic module which controls the timing and firing information. TIMING IS NOT CONTROLLED BY THE ECM on this kit, but is very simple, starts quick and runs well.  We do NOT provide spark plug wires, coil or the Pertronix for this kit.   You will need a laptop and cable to program the ECM if you want different running parameters (tuning) than stock and is very useful for diagnostics.  If you plan to install Air Conditioning, the AC pulley will interfere with the Trigger wheel and will require you send your Harmonic Balancer to us for modification and a special type of trigger wheel. 

Kit Contents

1 ea    Throttle body assembly w/Injector, Integral MAT, and TPS** 

3 ea    Throttle body assembly w/Injector** 

1 ea    Direct Link 4x linkage

1 ea    Fuel Line Right Side

1 ea    Fuel Line Left Side

1 ea    Fuel Line “T” to Tunnel line

1 ea    “S” Tube from Tank to Regulator

1 ea    Fuel Pressure Regulator/Filter

1 ea    Map Sensor, GM Type

1 ea    Narrow Band O2 Sensor

1 ea    Head/Engine Temp Sensor

1 ea    Fuel pump block-off with O-Ring

1 ea    Wiring Harness with Relays for TSP Distributor

1 ea    30 amp fuse assembly

1 ea    ECM Computer (pre-programmed and user adjustable)

1 ea    36-1 Trigger Wheel w/bolts and spacers

1 ea    Trigger Sensor Bracket

1 ea    Trigger Pickup Sensor

1 ea    Idle Air Control System

1 ea    USB to 2.5mm ECM to Laptop Cable

4 ea    *Carburetor core required  

Cores:   Send your cores when you order to allow time for the modifications to these items and avoid delays.  Your cores are must have a fairly straight Bell Crank, a throttle plate and throttle shaft that is free.  We only need the carb base, so remove the top before sending.  Unusable bases have to be thrown away, wastes your shipping and another set of cores will be needed.  A core charge will be charged for each unusable core.
Did you know that Brown EFI is intended for off-road use only?